CigarBanter

Advanced search  
Pages: 1 ... 11 12 [13] 14 15 ... 26

Author Topic: 1/11/2016  (Read 37722 times)

ss2

  • Founding Member
  • Senior Status
  • ****
  • Posts: 4039
  • Summertime!!
Re: 1/11/2016
« Reply #180 on: January 11, 2016, 09:53:24 AM »

G'Morning, Folks... Football ain't over yet.
Mornin' BS
Logged

sfish

  • Guest
Re: 1/11/2016
« Reply #181 on: January 11, 2016, 09:53:46 AM »

Good morning, men.
Morning Uncle Tone.
How's the bathroom coming, Mark? Getting ready to finish a basement here. Just completely clearing it out for now. Eventually, the bathroom will be built.
A couple of towel bars (on order) and f'n crown molding left to finish.  And the wife still has to pick out some mirrors.  And two medicine cabinets.  And, and, and......
I hear ya. I've done quite a bit of crown molding work. It's a pain in the ass. The secret is building a good jig so that you cut each piece at the same angle. I have two saws for that. Not sure where either of them are but I suspect I will find them this week.
I cheat and cut it at work.  We have a miter saw table setup which works well. So it's not the cutting part as much as the installing part which sucks. These are cabinets, not wall/ceiling molding.
Well, that and checking for the this side up arrows....
The warden ordered the cabinets.  I have no idea if they were available with the crown molding pre-installed.  Sorta doubt it, but that would have been the ticket for sure.
No such thing, how would you hang multiples? Rookies, sheesh
Where's logic come into it?
If you are hanging a run of cabinets, or just more than one, how are the cabinets going to butt to each other if crown goes around 3 sides. If crown is only on the fronts, there are seams at every cabinet and how would you return the side to the wall at the end of a run when the fronts are cut square at the end of the cabinet?
This is a bathroom, not a kitchen.  How many friggin cabinets do you have to hang.  What all you storing in there?  Putting in a wardrobe for costumes as well?
Doesn't matter, it's the reason they don't sell cabinets with crown attached. I've completely lost interest in this subject
DOES ANYBODY GIVE A CHIT THAT FISH HAS COMPLETELY LOST INTEREST?
I've also lost interest in your large red letters
Logged

BackyardSmoker

  • Smoke is good
  • Founding Member
  • Distinguished Status
  • *****
  • Posts: 8688
  • Back2Back
Re: 1/11/2016
« Reply #182 on: January 11, 2016, 09:55:53 AM »

GMornin fellas
Morning CG  - How bout that NDS - 5 in a row!
Indeed, glad to see you beat your Gamecocks as well.
Hopefully the big orange can get it done tonight!!!
Sure hope so.
They've got my vote!
I'll refrain from cheering for them, for Dave's sake. If the Bengals and Vikings are any indication, me rooting for a team leads to a painful demise.
No shit right - those Vikings...words can't describe that heartbreak.
#lacesoutdan
Both teams found very Browns ways to lose, no question.
Truth to that - just a bad way to lose.  Didn't score a touchdown all day, hard to blame a kicker who goes 3/4 in sub zero temps all day, but that's the 'life of a kicker'.
And those poor bastiges are usually near the bottom of the pay scale too.
He won them a couple of games this year too, so I hope he is still with the team next year.
The damn holder should be canned. He botched the hold in 3 of the 4 kicks. The kicker was lucky he made anything all day, when you add the shitty holds to the shitty weather.
The kicker shit the bed, nerves got the best of him on that kick. He hurried it and yanked the kick, plain and simple.
Yipped It Left Right?
We call it a 'pull hook' in the golf world

If you meant to do it, call it a draw... when you don't, snap hook.

Hey CG. How's about those BI-Zun! Not even close.
Logged

flip from jersey

  • Founding Member
  • Endeared Status
  • *****
  • Posts: 5457
  • We don't need no stinking apple, give me my Gurkha
Re: 1/11/2016
« Reply #183 on: January 11, 2016, 09:58:01 AM »

Good morning, men.
Morning Uncle Tone.
How's the bathroom coming, Mark? Getting ready to finish a basement here. Just completely clearing it out for now. Eventually, the bathroom will be built.
A couple of towel bars (on order) and f'n crown molding left to finish.  And the wife still has to pick out some mirrors.  And two medicine cabinets.  And, and, and......
I hear ya. I've done quite a bit of crown molding work. It's a pain in the ass. The secret is building a good jig so that you cut each piece at the same angle. I have two saws for that. Not sure where either of them are but I suspect I will find them this week.
I cheat and cut it at work.  We have a miter saw table setup which works well. So it's not the cutting part as much as the installing part which sucks. These are cabinets, not wall/ceiling molding.
Well, that and checking for the this side up arrows....
The warden ordered the cabinets.  I have no idea if they were available with the crown molding pre-installed.  Sorta doubt it, but that would have been the ticket for sure.
last time my warden ordered cabinets, it was 10% more for the crown molding, and another 10% for the chocolate wash finish.  that on already expensive rock maple cabinets.  Contractors burnt out a drill or two putting them up.  Good morning boys....
Logged

South Carolina Redfish

  • Coffee At Sunrise 🌄 and Cocktails At Sunset 🌅
  • Founding Member
  • Post Whore Extraordinaire
  • *****
  • Posts: 55869
  • “Retirement Is Wonderful”
Re: 1/11/2016
« Reply #184 on: January 11, 2016, 10:00:34 AM »

Good morning, men.
Morning Uncle Tone.
How's the bathroom coming, Mark? Getting ready to finish a basement here. Just completely clearing it out for now. Eventually, the bathroom will be built.
A couple of towel bars (on order) and f'n crown molding left to finish.  And the wife still has to pick out some mirrors.  And two medicine cabinets.  And, and, and......
I hear ya. I've done quite a bit of crown molding work. It's a pain in the ass. The secret is building a good jig so that you cut each piece at the same angle. I have two saws for that. Not sure where either of them are but I suspect I will find them this week.
I cheat and cut it at work.  We have a miter saw table setup which works well. So it's not the cutting part as much as the installing part which sucks. These are cabinets, not wall/ceiling molding.
Well, that and checking for the this side up arrows....
The warden ordered the cabinets.  I have no idea if they were available with the crown molding pre-installed.  Sorta doubt it, but that would have been the ticket for sure.
No such thing, how would you hang multiples? Rookies, sheesh
Where's logic come into it?
If you are hanging a run of cabinets, or just more than one, how are the cabinets going to butt to each other if crown goes around 3 sides. If crown is only on the fronts, there are seams at every cabinet and how would you return the side to the wall at the end of a run when the fronts are cut square at the end of the cabinet?
This is a bathroom, not a kitchen.  How many friggin cabinets do you have to hang.  What all you storing in there?  Putting in a wardrobe for costumes as well?
Doesn't matter, it's the reason they don't sell cabinets with crown attached. I've completely lost interest in this subject
DOES ANYBODY GIVE A CHIT THAT FISH HAS COMPLETELY LOST INTEREST?
I've also lost interest in your large red letters
LIGAF
Logged

BackyardSmoker

  • Smoke is good
  • Founding Member
  • Distinguished Status
  • *****
  • Posts: 8688
  • Back2Back
Re: 1/11/2016
« Reply #185 on: January 11, 2016, 10:01:02 AM »

Using a coping saw is a lost art, but I don't like to brag.  ;D
Logged

LuvTooGolf

  • Founding Member
  • Banter Elder
  • *****
  • Posts: 44708
  • Believeland!
Re: 1/11/2016
« Reply #186 on: January 11, 2016, 10:03:35 AM »

No one give a chit today!
Logged

BackyardSmoker

  • Smoke is good
  • Founding Member
  • Distinguished Status
  • *****
  • Posts: 8688
  • Back2Back
Re: 1/11/2016
« Reply #187 on: January 11, 2016, 10:03:36 AM »

G'Morning, Folks... Football ain't over yet.
Mornin' BS

Hey there, Sammie. Though them Skins would keep it closer... Fvckin discount double check
Logged

BackyardSmoker

  • Smoke is good
  • Founding Member
  • Distinguished Status
  • *****
  • Posts: 8688
  • Back2Back
Re: 1/11/2016
« Reply #188 on: January 11, 2016, 10:06:01 AM »

Logged

BackyardSmoker

  • Smoke is good
  • Founding Member
  • Distinguished Status
  • *****
  • Posts: 8688
  • Back2Back
Re: 1/11/2016
« Reply #189 on: January 11, 2016, 10:07:44 AM »

Golf goin' for the Oscuros today, huh...
Logged

sfish

  • Guest
Re: 1/11/2016
« Reply #190 on: January 11, 2016, 10:13:42 AM »

Golf goin' for the Oscuros today, huh...
That just means someone else will get a good deal
Logged

sfish

  • Guest
Re: 1/11/2016
« Reply #191 on: January 11, 2016, 10:14:59 AM »

Using a coping saw is a lost art, but I don't like to brag.  ;D
What's a coping saw?
Logged

ss2

  • Founding Member
  • Senior Status
  • ****
  • Posts: 4039
  • Summertime!!
Re: 1/11/2016
« Reply #192 on: January 11, 2016, 10:19:51 AM »

Using a coping saw is a lost art, but I don't like to brag.  ;D
What's a coping saw?
A saw that allows you to cope with even the worst of situations...
Logged

South Carolina Redfish

  • Coffee At Sunrise 🌄 and Cocktails At Sunset 🌅
  • Founding Member
  • Post Whore Extraordinaire
  • *****
  • Posts: 55869
  • “Retirement Is Wonderful”
Re: 1/11/2016
« Reply #193 on: January 11, 2016, 10:20:12 AM »

Using a coping saw is a lost art, but I don't like to brag.  ;D
U are probably one of 5 under age 100 if you. can use one well
Logged

LuvTooGolf

  • Founding Member
  • Banter Elder
  • *****
  • Posts: 44708
  • Believeland!
Re: 1/11/2016
« Reply #194 on: January 11, 2016, 10:20:14 AM »

Golf goin' for the Oscuros today, huh...
That just means someone else will get a good deal
But a slightly worse deal than I would've gotten.
Logged
Pages: 1 ... 11 12 [13] 14 15 ... 26