Good morning, men.
Morning Uncle Tone.
How's the bathroom coming, Mark? Getting ready to finish a basement here. Just completely clearing it out for now. Eventually, the bathroom will be built.
A couple of towel bars (on order) and f'n crown molding left to finish. And the wife still has to pick out some mirrors. And two medicine cabinets. And, and, and......
I hear ya. I've done quite a bit of crown molding work. It's a pain in the ass. The secret is building a good jig so that you cut each piece at the same angle. I have two saws for that. Not sure where either of them are but I suspect I will find them this week.
I cheat and cut it at work. We have a miter saw table setup which works well. So it's not the cutting part as much as the installing part which sucks. These are cabinets, not wall/ceiling molding.
Well, that and checking for the this side up arrows....
The warden ordered the cabinets. I have no idea if they were available with the crown molding pre-installed. Sorta doubt it, but that would have been the ticket for sure.
No such thing, how would you hang multiples? Rookies, sheesh
Where's logic come into it?
If you are hanging a run of cabinets, or just more than one, how are the cabinets going to butt to each other if crown goes around 3 sides. If crown is only on the fronts, there are seams at every cabinet and how would you return the side to the wall at the end of a run when the fronts are cut square at the end of the cabinet?